Home > News > Content
Roller Bearings Be Sure To Pay Attention To Daily Maintenance
Jun 27, 2017

1, Roller Bearings into the Roller Bearings should be flexible after the rotation without blocking sense. If there is a clear rotation is not flexible, it means that the size of the shaft is too large, the tolerance to be reduced. If the Roller Bearings press the shaft after hand rotation with a clear "rust" feeling, it may be too much tolerance of the shaft or shaft roundness is not good. So in the control of shaft and thrust roller bearing room tolerance to control the roundness, the current domestic manufacturers only to control the tolerance, there is no control of the roundness.

2, thrust roller bearing assembly: Because the Roller Bearings are high-precision products, such as improper assembly is easy to cause damage to the thrust roller bearing channel, resulting in damage to the Roller Bearings. Roller Bearings in the assembly should have a dedicated mold, can not be tapping, in the press into the shaft when only a small circle of force, pressure circle can only large circle force. Assembly requirements of the use of air pressure or hydraulic pressure in the upper and lower mold to be outside the horizontal state, if the tilt will lead to thrust roller bearing channel due to damage to the force, leaving the thrust roller bearing guide.

3, the installation of foreign body to prevent: Roller Bearings in the load on the rotor to do when the dynamic balance is easy to balance the iron into the Roller Bearings into the internal, so it is best to install Roller Bearings before the dynamic balance The There are some manufacturers in order to facilitate the assembly, the assembly in the thrust roller bearing room coated with some oil or grease from the lubrication effect, but often the operator is difficult to control the amount of good, if the oil or grease in the thrust roller bearing room accumulated more , It is easy to enter the thrust roller bearing along the shaft when the thrust roller bearing is rotated. Thrust roller bearing chamber is best not to oil or grease, such as non-coated can not be controlled in the thrust roller bearing room can not stay.

4, the prevention of paint rust: paint rust is characterized by multiple in the sealed motor, the motor sound in the assembly is very good, but put some time in the warehouse, the motor varies greatly, remove the thrust roll Sub-bearing a serious rust phenomenon. Many manufacturers will think that before the thrust roller bearing the problem, through our continuous publicity, and now the motor factory has been aware of the problem is mainly insulating paint. The problem is mainly because the insulating material volatilizes the acidic substances in a certain temperature, humidity, the formation of corrosive substances, the thrust roller bearing channel corrosion caused by Roller Bearings damaged. The problem is currently only a good choice of insulating paint, and after the ventilation in a period of time after the assembly. Roller Bearings in the use of the process, the most important is the length of life. The length of life and bearing the manufacture, assembly, use are closely related. In the use of the process must pay attention to the daily maintenance.


Subscribe to our email list
Sign up with your name and email to get the latest proway updates, exclusive access to promotions, sales events, pre-order sales & more!
Connect with HANQI
Become our fan, follow us & subscribe for the latest updates and deals
QR Code
  • About Us
  • Products
  • News
  • Knowledge
  • Contact Us
  • Feedback
  • Copyright © Cixi HANQI Rolling Co.,Ltd All rights reserved.